Josh Setup Guide
Josh Touchscreen
Step 1
Step 1
Remove mounting plate from touchscreen.
Loosen the two screws on the sides until the mounting plate can pull away from the back of the Touchscreen. Keep the screws threaded just enough to pull off the plate without fully removing them from the Touchscreen. We suggest using the Phillips PH#0 screwdriver for installation.
Step 2
Step 2
Attach mounting plate to single-gang box.
Use the supplied screws to fix the metal mounting plate to the single gang box. The plate must be mounted horizontally.
Step 3
Step 3
Plug POE cable into the back of the touchscreen.
Thread the POE cable through the center of the mounting plate and plug it in to the back of the Touchscreen.
Step 4
Step 4
Secure touchscreen to the mounting plate.
Slide the Touchscreen onto the mounting plate, making sure that the screw fixtures fit into the recesses in the back of the device. The back of the Touchscreen should be flush with the plate. Then tighten the screws until the touchscreen is secure.
Step 5
Step 5
Complete setup.
Remove the screen cover and complete the guided setup instructions. If not connected to POE then follow the wifi setup wizard to connect to internet.
